[2.5.7] Rocking It in the Treble
The most difficult notes to tune are the highest ones. Here you need incredible accuracy in moving the strings and the beats are difficult to hear. Beginners can easily lose their bearing and have a hard time finding their way back. One advantage of the need for such small motions is that now, you can use the pin-rocking motion to tune. Since the motion is so small, rocking the pin does not damage the pinblock. To rock the pin, place the lever parallel to the strings and pointing towards the strings (away from you). To tune sharp, pull up on the lever, and to tune flat, press down. First, make sure that the tuning point is close to the center of the rocking motion. If it is not, rotate the pin so that it is. Since this rotation is much larger than that needed for the final tuning, it is not difficult, but remember to correctly set the pin. It is better if the tuning point is front of center (towards the string), but bringing it too far forward would risk damaging the pinblock when you try to tune flat. Note that tuning sharp is not as damaging to the pinblock as tuning flat because the pin is already jammed up against the front of the hole.